Facebook Support Forum

Click on this link to be taken to the Facebook forum to post and get support

This a forum to share Projects, Files, and ask questions of other Arclight Dynamics table owners

We have cut fine 45amp 10g since we got the table (2months ago) all of a sudden last night it cut like crap and was fusing it back together and going insanely fast but no settings were different. We changed tip and checked allll settings over over. Anyone know why this would happen ...

View on Facebook

Does anyone know why this could be running so bad? I'm using a 105 power max. I set the tool to fine cut 45 amp 10 gauge. I'm running a fine cut shield and tip 220948 shield, 220930 tip. The machine looks like it hovers about a quarter of an inch away from the material before cutting and the holes are really off ...

View on Facebook

What's everyone's favorite way to clean the slats? ...

View on Facebook

Had a cut stop half way through a sheet. When I try to resume where it stopped it starts over at the beginning. Any help? Thanks. ...

View on Facebook

Need a little help again…. My Arclight machine is about 3-4 years old and I have never had any real issues with it other than stupid stuff I’ve done incorrectly learning . Yesterday while cutting the machine stopped moving from left to right. I thought it must be something with the file so I recreated it and ran it back thru sheetcam and attempted to cut it again. This time it cut past the part that it stopped moving left to right the time before however later into the cut it stopped moving left to right again. When this occurs I also cannot move the machine left to right manually with the key board. At this point I powered everything off and rebooted the computer/controller/plasma. Started everything back up and it worked great for about 10 mins then no left and right movement again. Anyone else seen this or have any suggestions that I can try to correct before calling Arclight on Monday ? As always many thanks to this group….. ...

View on Facebook

Inline
Inline